and 146: Note: For an external disk to be bo.and 142: The specific Proactive Backup optio. When you are ready to perform the restore, click Start Now. The Restore Options pane appears, recapping the source and destination of the copy. Click the radio button next to the name of the destination volume, then click Continue. When you have found and selected the backup you want, click Continue. Look through the list of backups until you find the backup that reflects the point in time to which you want to restore. Choose “Restore an entire source volume or favorite folder to a previous point in time,” then click Continue. In the Retrospect toolbar, click Restore. From the Sources category of the Retrospect console, Remove the old Linux client, then Add the new client. Use the Setup program to install the Retrospect client software as described in “Installing Retrospect Client software on a machine running Linux” in Chapter 1. Install new Linux operating system software on the newly-formatted hard disk, making sure to create the same mount points as the original system. The steps below involve completely replacing the contents of a client computer’s hard drive with a previous backup in which you backed up “all files.” 1. You must first get the client computer operating with the network before performing the actual restore operation from the backup computer. These instructions assume that you have a newly erased disk that has had installed a fresh copy of the Linux operating system distribution. Restoring a Linux Client The following instructions describe how to restore an entire volume on a Linux client over the network. When it finishes, your computer is ready to use. The Retrospect Helper service runs automatically and finishes restoring the registry and System State.
0 Comments
Leave a Reply. |